- About 8500 frame hours- 3500 on new reman engine
- The COP 1238ME Hammer is a fresh rebuild by ATLAS COPCO.
The feed beam or tower in the photo is about to be replaced that’s why the hoses and hammer are off the rig.
Unit also comes with Hydraulic winch,
rear support jack,
dual boom controls
150 CFM onboard compressor along with a rod rack,
hydraulic centralizer set up for T45 Drill steel.
Rig is capable of 2”-3.5” hole diameters 60 feet deep.
2005 Atlas Copco ROC D3 3196 Total Hours Rebuilt 1238 ME drifter "0" hours Rod rack Dust collector Immaculate condition Ready to work!
2001 Atlas Copco L8
2001 AVO 01A544
Has a new batteries
New DCT Filters
New separator tank and filter
New air end/coupling
4 drill pipe/ full rack
DHR48HD Rotary head rebuilt
New upgraded steel fuel tank
New pressurized water vessel
Wabasco fuel fired block heater
Dust collection, water mist, engine pre-heat, upper winch, digital angle indicator
'2005 Atlas Copco ROC F9-11' serviced, prepped and ready for work; Rebuilt hammer -COP 2550 , new centralizer halves, no leaks, Cabin with AC/Heat, engine pre-heat system, rear support jack, rod changer set up for T51 rods and 96 foot drill depth, 450 CFM onboard compressor, work lights, boom, hammer and boom slides all have new wear strips